# Spray Gun Technique for Car Paint: Pattern Overlap and Passes

Learn how to set the fan pattern, overlap each pass, hold gun distance steady and control the trigger for an even paint coat on car panels.

Spray gun technique for car paint comes down to a steady fan pattern, a consistent gun distance, and passes that overlap the one next to them. Each pass lays a stripe of paint, and the next pass must cover part of the stripe before it so the panel builds an even paint coat instead of stripes or dry edges. Trigger control ties the passes together, because the gun should start and stop its spray at the edges of the panel. 

## Setting the fan and overlap 

A fan pattern is the shape of the spray the nozzle throws, and its width sets how much each pass covers. Adjust the pattern at the gun before painting, then overlap each pass by half the fan width so no gap falls between stripes. A fifty percent overlap is the reference point learners work from, because it lets each pass blend into the one before. A narrow fan needs more passes across the panel, while a wide fan covers more ground but is harder to keep even. 

## Keeping gun distance steady 

Gun distance is the gap between the nozzle and the panel, and holding it steady keeps the fan width and the paint deposit even. Move the gun closer and the paint piles up and can run, while moving it away dries the spray before it lands. Keep the wrist locked and move the whole arm across the panel so the distance stays the same through the pass. Follow the shape of the panel with the arm, not by tilting the wrist. 

## Trigger and pass speed 

Trigger control means pulling the trigger after the gun starts moving and releasing it before the pass ends. Pass speed is how fast the gun crosses the panel, and an even speed lays an even film of paint. Slow down and the coat builds too wet, while rushing leaves a thin, grainy stripe. Keep the gun square to the surface through each pass so the fan hits the panel flat. 

## Questions about spray pattern overlap 

### What does paint spray pattern overlap mean? 

Paint spray pattern overlap is the share of one pass that the next pass covers with fresh paint. Overlapping passes by half the fan width blends each stripe into the previous one. Without overlap, the edges of each pass receive less paint and show as stripes on the finished panel. The overlap also covers the lighter edges a fan leaves at its sides. 

### How do I set the fan pattern on a spray gun? 

You set the fan pattern with the pattern adjustment on the gun before you start spraying. Test the spray on a scrap panel and check the shape and width of the stripe it leaves. A fan with heavy edges or a split center needs adjustment before you paint the car. Set the fluid and air controls after the pattern is correct. 

### How far should the spray gun be from the car? 

The right gun distance depends on the gun and the product, so follow the maker's instructions for your setup. Keep that distance the same across the whole panel by moving your arm rather than your wrist. A distance that changes through a pass makes the paint uneven across the surface. Test the distance on scrap material before you work on the car. 

### Does pass speed change how the paint lands? 

Pass speed changes how much paint lands on the panel, because a slow pass leaves a wetter coat than a fast one. Keep the speed even from the first pass to the last so the coat builds evenly. Match the speed to the overlap so each pass blends without running or drying rough. Practice an even rhythm on scrap before painting a visible panel.
