# Socket Size Metric to Imperial Conversion Chart

See how metric socket sizes match imperial sizes, which pairs are close enough to swap, and how drive size differs from the socket opening.

A socket size metric to imperial conversion chart pairs each millimeter socket with its nearest fractional inch size. The conversion itself is simple, because one inch equals exactly 25.4 millimeters. Few pairs match exactly, so a good chart flags swaps that risk rounding a fastener. 

## Metric and imperial sizes that nearly match 

Several metric sockets sit within a fraction of a millimeter of an imperial size. A 19 mm socket measures about 0.748 inch, nearly identical to 3/4 inch. Similarly, 13 mm is about 0.512 inch, slightly larger than 1/2 inch. A 16 mm socket at about 0.630 inch sits close to 5/8 inch, which is 0.625. 

## Socket pairs that should not be swapped 

Some metric and imperial sockets look interchangeable but differ enough to damage a fastener. A 10 mm socket is about 0.394 inch, noticeably larger than a 3/8 inch socket at 0.375. A loose socket can round the corners of a nut or bolt head under force. Using the matching system gives full contact on the flats, the flat sides of the head. 

## Drive size versus socket opening size 

Drive size is the square hole that connects a socket to a ratchet or wrench. Drive sizes are stated in inches, such as 1/4, 3/8, 1/2 and 3/4 inch, even on metric sets. The opening size, printed on the socket body, is the figure a conversion chart compares. A socket wrench size chart may list both, so check which column you are reading. 

## Socket size conversion questions 

### How do you convert mm to inches for a socket? 

Converting a metric socket to inches means dividing the millimeter size by 25.4. Then compare the decimal to fractions such as 0.5 for 1/2 inch or 0.625 for 5/8 inch. To go the other way, multiply the fractional inch value by 25.4. 

### Can I use metric sockets on imperial bolts? 

Yes, a metric socket can work on an imperial bolt when the two sizes nearly match. A 19 mm socket on a 3/4 inch bolt is one example of a close fit. Where the gap is larger, the socket can slip and round the bolt head. For fasteners tightened with heavy force, use the matching system whenever you have it. 

### Are metric and imperial drive sizes the same? 

Yes, drive sizes are the same on metric and imperial sockets because both use inch-based squares. A 3/8 inch drive metric socket fits the same 3/8 inch ratchet as an imperial one. Only the opening that grips the fastener changes between the two systems. 

### How can I tell if a fastener needs a metric or imperial socket? 

The surest test for a fastener is to try the closest metric and imperial sockets in turn. The correct socket slides on snugly and shows no wobble when you rock it gently. Any play means the size is off, even if the chart numbers look close. For equipment repairs, the manufacturer's documentation may state which system the hardware uses.
