Parasitic Draw Test With a Multimeter

Learn how a parasitic draw test with a multimeter works: amp setting, series connection at the battery negative terminal, draw readings and fuse removal checks.

3 min read2 viewsParasitic Draw Test With a Multimeter
— · 0 votes
Contents
  1. Setting the meter to amps
  2. Connecting the meter in series
  3. Reading the draw and pulling fuses
  4. Questions About Parasitic Draw Testing
  5. How do I test for parasitic draw with a multimeter?
  6. Which multimeter setting do I use for a parasitic draw test?
  7. Where does the meter connect during a draw test?
  8. Can I find a battery drain by pulling fuses?

A parasitic draw test with a multimeter measures the current a parked vehicle keeps taking from its battery after everything is switched off. The meter goes in series with the battery negative terminal on the amp or milliamp setting, and the reading shows whether something is draining power. You then pull fuses one at a time to find which circuit carries the draw.

Setting the meter to amps

A multimeter amp setting turns the meter into an ammeter that current flows through rather than a voltmeter that reads across a circuit. Select the milliamp setting for small expected drains and the higher amp range when the reading may be larger. Meter leads must move to the current sockets, because the voltage sockets will not measure flow. Check the meter's current rating before you connect it to a battery circuit.

Connecting the meter in series

A series measurement places the meter in the path of current instead of across two points. Disconnect the battery negative terminal and connect one test lead to the battery post and the other to the disconnected cable clamp. All current feeding the vehicle then passes through the ammeter. Keep the terminal firmly connected through the meter so the vehicle does not lose power and wake modules.

Reading the draw and pulling fuses

A draw reading above the vehicle maker's specification points to a circuit that stays awake or a component that fails to shut down. Watch the reading for several minutes, because some modules go quiet only after a delay. Fuse removal draw checks work by pulling one fuse at a time and noting when the current drops. Replace each fuse before pulling the next and record which circuit changed the reading.

Questions About Parasitic Draw Testing

How do I test for parasitic draw with a multimeter?

A parasitic draw test with a multimeter is done by placing the meter in series with the battery negative cable on the amp or milliamp setting. You then read the current after the vehicle goes to sleep and pull fuses to isolate the circuit. Do not crank the engine or turn on heavy loads while the meter is inline, because the current can exceed the meter's rating.

Which multimeter setting do I use for a parasitic draw test?

The multimeter milliamp setting suits small drains, while the amp setting covers larger ones. Match the range to the expected draw and move the leads to the current sockets first. A reading that stays at zero on one range may simply mean the current is below that range's resolution.

Where does the meter connect during a draw test?

The ammeter connection goes between the battery negative post and the negative cable clamp. This series position forces all vehicle current through the meter. Do not connect the meter across the two battery posts on the amp setting, because that creates a short circuit.

Can I find a battery drain by pulling fuses?

Fuse removal can locate a battery drain, but the meter must stay connected in series during the check. Pull one fuse at a time and watch the draw reading for a drop. Circuits that feed safety or security systems may need a specialist to test safely, so stop and get trained help for those.

Read next

Latest articles