How to Read a Non-Digital (Analog) Multimeter

Learn how to read a non-digital multimeter: choosing a range on the selector, reading the needle scale, using the mirror scale and adjusting meter zero.

3 min read1 viewsHow to Read a Non-Digital (Analog) Multimeter
— · 0 votes
Contents
  1. Match the needle scale to the setting
  2. Set range before you take a reading
  3. Zero the meter and read the mirror scale
  4. Questions about reading analog multimeters
  5. How do I read between two scale markings?
  6. What is the mirror scale for on an analog meter?
  7. When do I adjust the zero of the meter?
  8. Why does the needle swing past the scale?

To read a non-digital multimeter, you pick the function and range on the selector, then read the needle position against the scale that matches that setting, following the printed numbers on the face. An analog multimeter shows its value with a moving needle instead of digits, so the reading depends on which scale you look at and how you line up your eye with the pointer. The page explains the scale layout, the range selector, zero adjustment and the mirror scale, along with what each step means in practice.

Match the needle scale to the setting

A non-digital multimeter face carries several curved scales, and the needle points to all of them at once. The range selector tells you which scale applies, so a direct voltage setting sends you to the row marked for volts. Follow the printed numbers on that row and ignore the other arcs until you change the selector.

Set range before you take a reading

The range selector sets the largest value the meter can show on a given scale. Choose a range above the value you expect, then step down to a tighter range so the needle sits well across the arc. A needle pinned at the end of the scale means the value is beyond that range, so the next step is a higher setting.

Zero the meter and read the mirror scale

Analog meter zero adjustment moves the needle to the zero mark at the left of the scale with the probes apart. The mirror scale is a curved strip behind the needle that removes the lean of your viewing angle. Line the needle tip up with its reflection in the mirror, and the value under the pointer is the reading.

Questions about reading analog multimeters

How do I read between two scale markings?

Reading between scale markings calls for estimating the fraction of the gap the needle has crossed. If the pointer sits partway between two numbers, note how far it has moved toward the next mark. Write the estimate as a value between the two marks, because an analog needle gives a position rather than a digit.

What is the mirror scale for on an analog meter?

The mirror scale on an analog meter removes reading error caused by viewing the needle at an angle. When your eye is off to one side, the needle and its reflection separate. You move your head until they overlap into one line, which puts your eye straight on the pointer.

When do I adjust the zero of the meter?

Meter zero adjustment is done with the probes separated so no circuit is connected. The small screw on the face moves the needle until it rests exactly on the zero mark at the left end. Old or knocked meters drift, so check the zero setting each time you pick the instrument up.

Why does the needle swing past the scale?

A needle that swings to the end of the scale indicates a value larger than the selected range allows. The range selector is set too low for what you are measuring. Move the selector up to a higher range, then work back down until the needle rests comfortably on the arc.

Read next

Latest articles