# How to Measure Bearing Wear

Learn how to measure bearing wear with a dial indicator, checking radial clearance and axial play during a wear inspection on shafts and housings.

How to measure bearing wear comes down to checking the play between moving parts, because a worn bearing lets a shaft move further than it should. A dial indicator mounted on a firm base records that movement as radial clearance and axial play. The readings you take become the facts you bring to a service provider when you discuss the repair. 

## Set up the dial indicator 

A dial indicator measures small movements, so its mounting decides whether a bearing wear reading means anything. Clamp the indicator base to a rigid part of the machine and not to the shaft you are testing. Touch the indicator tip to a clean, smooth surface on the shaft or housing and preload it slightly. Any flex in the stand shows up as movement in the needle, so check the mount before you trust a number. 

## Read radial clearance first 

Radial clearance is the movement of the shaft across its axis, and it shows bearing play in the direction of load. Push the shaft firmly toward the indicator and set the needle to zero, then push it the opposite way and read the travel. Take the reading at the same point with the shaft rotated to several positions, because wear can be uneven around the race. A dial indicator with fine graduations gives a clearer value on small movements. 

## Check axial play at the end 

Axial play is the end-to-end movement of the shaft, and it responds to thrust loads rather than side loads. Set the indicator tip against a square face at the end of the shaft and zero the dial with the shaft pushed one way. Push the shaft the other way and note the travel, keeping the force steady and free of shock. Record axial play beside the radial figure, since the two together describe the wear inspection. 

## Questions About Bearing Wear Measurement 

### How do you measure bearing wear on a shaft? 

Bearing wear on a shaft is measured by fixing a dial indicator to a rigid base and reading how far the shaft moves. You compare the radial clearance and the axial play against the limits the bearing maker specifies. Clean surfaces and a steady push on the shaft keep the reading honest. A worn bearing shows as movement beyond the permitted play. 

### What is the difference between radial clearance and axial play? 

Radial clearance is side-to-side movement across the shaft axis, while axial play is movement along the shaft axis. Radial clearance reflects the gap between the rolling elements and the races under load. Axial play shows how much the shaft slides end to end. Both readings belong in the same inspection record. 

### Can I check bearing play without a dial indicator? 

Bearing play can be checked by feel, but a dial indicator gives a number you can compare with a limit. Hand checks reveal obvious looseness and rough rotation, yet they miss small amounts of wear. Feeler gauges suit some clearance checks where a gap can be reached. For a value you can discuss with a service provider, use a dial indicator. 

### When should a trained specialist measure bearing wear? 

A trained specialist should measure bearing wear when the machine must be dismantled, when the bearing sits in a hot or guarded assembly, or when a wrong reading risks damage. Access to the shaft may require lockout of power and removal of guards. Some bearings need a press or heat for removal, which is specialist work. Stop and call a technician when the setup is beyond safe reach.
