How to Measure a Motorcycle Windshield for Replacement
Learn how to measure a motorcycle windshield for replacement, taking height, width and mounting points so a new screen fits your bike correctly.
Contents
- Measure windshield height correctly
- Record width and mounting points
- Work from a broken or missing shield
- Motorcycle windshield measuring questions
- How do you measure a windshield for a motorcycle?
- Where does windshield height start and end on a motorcycle?
- Can I measure a replacement screen without the old one?
- Should width and mounting points be measured too?
Measuring a motorcycle windshield for replacement means recording its height, its width and the spacing of its mounting points before you order a new screen. This page explains where each measurement starts and ends, which tools to use, and how those figures guide motorcycle fitment. It also covers what to do when the old shield is broken or missing so your estimate stays accurate.
Measure windshield height correctly
Windshield height on a motorcycle is measured vertically from the lowest mounting edge to the top edge of the screen. Lay a tape or a straight rule parallel to the shield instead of following its curve, because a curved path adds length that the screen does not have. Some riders compare that figure to the height they want at eye level, which depends on their seating position and posture. Record the vertical height on its own line so the replacement quote matches the part you need.
Record width and mounting points
Windshield width is the widest horizontal span of the screen, measured across the face at its broadest point. Mounting points are the holes or brackets that hold the screen to the fork or fairing, and their spacing decides whether a new screen attaches at all. Measure from center to center of each pair of holes, then note the hole diameter and the angle of the mounting surface. A screen with the right height and width can still fail motorcycle fitment when the hole pattern differs.
Work from a broken or missing shield
A cracked or missing motorcycle windshield leaves you without a direct outline to copy. Photograph the remaining pieces against a flat surface and tape the fragments together on a sheet of paper before measuring them. When no part remains, measure the mounting bracket openings and the fairing opening, then describe the shape you need in words and a sketch. A trained specialist can confirm the measurements when the original screen is too damaged to read.
Motorcycle windshield measuring questions
How do you measure a windshield for a motorcycle?
Measure a motorcycle windshield by recording its vertical height, its widest width and the spacing of its mounting holes. Use a tape or straight rule held parallel to the screen so the curve does not inflate the figures. Write each measurement down with the unit you used and keep the note with your estimate. Give those figures to the service provider so the replacement screen matches your bike.
Where does windshield height start and end on a motorcycle?
Windshield height runs from the lowest mounting edge of the screen up to its top edge, measured straight rather than along the curve. Start the tape where the screen meets the bracket or fairing and stop at the highest point of the glass. A taller screen changes the wind protection you feel, so note the height you want as well as the height you have. Keep both numbers separate on your estimate.
Can I measure a replacement screen without the old one?
You can measure a replacement motorcycle windshield without the old screen by working from the mounting brackets and the fairing opening. Record the center-to-center spacing of the holes, the hole size and the shape of the opening, then sketch the outline you need. Photographs of the front of the bike from level and from the side help a supplier read the shape. A trained technician can verify the figures before any glass is ordered.
Should width and mounting points be measured too?
Width and mounting points must be measured along with height for a motorcycle windshield replacement. Width sets how far the screen reaches across the bike, and the hole spacing decides whether it bolts on without new drilling. Measure width at the broadest point and hole spacing from center to center of each pair. A screen that is close in height can still miss on width or hole pattern.