# How to Apply and Thin Bondo Glazing Putty

Steps for applying Bondo glazing putty to a car panel, thinning it when it drags, spreading thin coats and sanding the repair smooth before primer.

Bondo glazing putty is a fine filler for small pits, scratches and sanding marks left after body filler work, and this page explains how to apply it and how to thin it. You will find how the hardener is mixed, when a spreader or mixing board helps, how thin coats are spread, and how sanding finishes the repair. Each step names what it depends on so you can plan the work before you start. 

## Mixing putty with hardener 

Bondo glazing putty is a two-part product, and the tube of hardener must be mixed into the paste before it is spread. The mixing hardener ratio matters because too little hardener leaves a soft film that clogs sandpaper. Too much hardener makes the putty set before you can smooth it, so mix a small batch you can use in one pass. Fold the paste and hardener together on a mixing board until the color is even, with no streaks. 

## Thinning putty that drags 

Thinning glazing putty is done when the paste pulls or leaves ridges instead of flowing into small defects. A few drops of the thinner named on the product label, worked in thoroughly, loosen the paste without turning it watery. Adding thinner weakens the film, so thin only as much as the spread needs and never top up a batch that has started to set. Check the label first, because some glazing putties are ready to spread and should not be thinned at all. 

## Spreading thin coats and sanding 

Spreading thin coats with a flexible spreader fills pinholes better than one heavy layer and keeps the repair level with the panel. Press the spreader at a low angle and draw the putty across the defect in one direction, then scrape the excess back onto the mixing board. Sanding glazing putty begins after it hardens, using a fine grit wrapped on a flat block to avoid gouging the surrounding paint. Stop sanding when the surface feels smooth and the pits are gone, then clean the dust before primer. 

## Questions about glazing putty 

### How do you apply glazing putty on a car? 

Glazing putty goes on a clean, sanded panel after the deeper filler has cured and been shaped. Mix a small batch with hardener, load a flexible spreader, and draw a thin coat across the pits and scratches. Let it harden, then sand it level with a fine grit on a flat block. 

### How do you thin Bondo glazing putty? 

Bondo glazing putty is thinned by stirring a small amount of the thinner named on its label into the paste before the hardener goes in. Add it a little at a time until the putty spreads without pulling. Some glazing putties are formulated to spread as sold, so read the label before adding anything. 

### How do you use Bondo glazing putty correctly? 

Bondo glazing putty is used in thin layers over small defects, not as a substitute for structural body filler. Mix only what you can spread in one pass, because the paste hardens once the hardener is added. Sand it smooth after it sets, then remove the dust before applying primer. 

### Does glazing putty need a hardener? 

Glazing putty that comes as a two-part product does need its hardener, and the tube supplied with the container is mixed into the paste. The hardener cures the putty so it can be sanded flat. Follow the mixing hardener ratio on the label, because an uneven mix leaves soft or brittle spots.
