# Finding a Local ADAS Calibration Shop

How to find a local ADAS calibration provider, check equipment and certification, compare dealer and independent shops, and ask the right questions before booking.

Finding a local ADAS calibration shop means locating a provider that owns the targets, positioning space and scan tools your vehicle's driver-assist cameras and radar require. The work restores the aim of sensors after a windshield replacement, wheel alignment, collision repair or suspension change. This page explains how to screen candidates, what certification to look for and which questions to ask before you book. 

## Matching the shop to the system 

An ADAS calibration shop must match its equipment to the specific driver-assist system on your vehicle. Camera calibration often uses target boards set at measured distances on a level floor with controlled lighting. Radar and lidar units may need a different rig or an open reflective area. Ask whether the shop has confirmed your make, model and model year against its tooling before it schedules the work. 

## Dealer versus independent calibration 

A dealer and an independent calibration provider differ in tooling access and scheduling rather than in the principle of the work. Dealers hold factory scan tools and software subscriptions, which helps with newer models and locked modules. Independent shops may invest in multi-brand targets and programming subscriptions that cover several makes. Compare both on whether their equipment list names your vehicle and whether they can complete any required module programming. 

## Paperwork and pre-scan records 

A calibration visit should leave a record you can attach to a repair estimate or insurance file. Ask for a pre-scan report, the calibration printout and a post-scan showing no fault codes remain. Shop calibration certification, such as training records for the technicians, supports that paperwork. Keep these documents with the invoice so a later owner or insurer can see the sensors were aimed to specification. 

## Questions about ADAS calibration shops 

### How do I find an ADAS calibration shop near me? 

Finding an ADAS calibration shop near you starts with asking which local providers own the targets and scan tools your vehicle needs. Windshield shops, collision centers and dealers often hold calibration equipment, so call and ask for the equipment list by make and model. Confirm the shop has a level floor area large enough for the target distances. Verify the address and hours before you drive over. 

### What certification should a calibration shop hold? 

A calibration shop should show technician training records and equipment documentation for the systems it services. Certification from an industry training body or an automaker program indicates the staff has been instructed on target placement and scan procedures. Ask to see the certificate scope, because it may cover cameras but not radar. The paperwork from your own calibration matters as much as the wall certificate. 

### Can a collision shop with calibration equipment do the work? 

A collision shop with calibration equipment can perform the work when its targets and scan tools match your vehicle's driver-assist system. Collision centers often handle camera and radar aim after body repairs, and some hold multi-brand tooling. Ask whether the shop calibrates in-house or sends the vehicle to a specialist. Confirm who signs the calibration report before you approve the repair. 

### What questions should I ask a calibration shop? 

Questions to ask a calibration shop cover equipment, training, scan records and the conditions of the calibration bay. Ask which targets and software the shop uses for your model, and whether it performs a pre-scan and post-scan. Confirm the floor is level and the lighting is controlled, since those conditions affect camera aiming. Request the calibration printout so you can file it with your estimate.
