Choosing Jack Stands: Buying Guide, Safest Picks and Sizing
Learn how to choose jack stands by matching load rating and lift height to your vehicle, comparing ratchet and pin styles, and placing stands safely.
Contents
Choosing jack stands means matching a pair's load rating and lift height to the vehicle you are raising, then picking a locking style you can operate correctly. The stand must hold the weight of the corner it supports, so the rating and the saddle height matter more than the look of the stand. This page covers sizing, rating, ramps as an alternative and safe placement.
Reading load rating and tonnage
A jack stand rating states the weight a single stand is built to hold, and tonnage is that figure expressed in tons. Buy stands rated well above the load you expect at one corner, because a floor jack lifts one end while two stands carry it. The rating is set by the manufacturer, so check the label on the stand itself rather than an online listing.
Sizing stands to lift height
Jack stand sizing depends on the height of your vehicle's jacking point once it is raised. A stand that is too tall will not slide under a low car, and a short stand leaves no room to work underneath. Adjustable stands cover a range of lift heights, and the pin or ratchet must lock at the height you need before you lower the vehicle.
Ratchet, pin and ramp options
Ratchet-style stands adjust smoothly and lock with a toothed bar, while pin-style stands lock through a hole in the post. Both are forms of vehicle support equipment, and each demands that the locking part sits fully engaged. Ramps suit jobs where you need the wheels to stay loaded, but they only fit certain tire sizes and leave no room to remove a wheel.
Jack stand questions answered
What size jack stands do I need?
The size you need is set by your vehicle's weight at one corner and by the height of its jacking points. Pick a stand whose rating exceeds that corner load and whose lift height range reaches the raised vehicle. A stand that fits the height but not the load, or the reverse, is the wrong size for the job.
What are good jack stands for car repair?
Good jack stands for car repair have a clear load rating, a locking mechanism that engages fully and a flat saddle that grips the jacking point. A wide base adds stability on a hard, level surface. Inspect the welds and the locking teeth before each use and discard a stand with cracks or a bent post.
Are ramps safer than jack stands?
Ramps are not safer than jack stands in every case, because each supports a vehicle differently. Ramps hold the wheels under load and suit fluid changes, while stands let you remove a wheel and work at a corner. Choose based on the job, and use wheel chocks with either option on level ground.
Where should jack stands be placed under a car?
Jack stands belong under the manufacturer's designated lift points, which are reinforced sections of the vehicle's frame or pinch weld. Place them on a hard, level surface and lower the floor jack slowly until the weight rests fully on the stands. Never put a stand under a floor pan, a plastic panel or a suspension part that can move.