Choosing a Socket Set
A plain guide to choosing a socket set: match drive size to the work, pick metric or SAE, and decide between deep and shallow, six and twelve point.
Contents
Choosing a socket set comes down to matching the drive size, socket type and piece count to the fasteners you actually turn. A socket set is a ratchet handle plus removable sockets that fit over a bolt or nut head. The guide below explains drive sizes, metric versus SAE sizing, deep and shallow sockets, point count and impact rating so you can compare sets on the facts.
Drive size sets the scale of work
Drive size is the square peg on the ratchet that the socket clips onto, given in fractions of an inch. A quarter-inch drive suits small fasteners in tight spaces, while three-eighths drive covers a wide middle range of engine and body work. Half-inch drive handles larger fasteners that need more turning force. Choose the drive size that matches the fasteners on your job, and expect the socket walls and handle length to grow with it.
Metric and SAE sizing
Metric sockets are marked in millimeters and SAE sockets in fractions of an inch, and the two systems do not interchange. A socket that is close but not exact can round the corners of a bolt head under load. Check which system the vehicle or equipment uses before you buy, and choose a set that covers that system across the sizes you need. A set that mixes both systems in one case saves space but can leave gaps in either range.
Deep, shallow and point count
Shallow sockets grip a nut close to the surface, while deep well sockets reach over a long stud or threaded rod. Six-point sockets contact the flats of a fastener and resist rounding, and twelve-point sockets fit in tighter swing arcs on hex heads. Impact-rated sockets are built for powered impact wrenches and carry a heavier wall than hand sockets. Match the socket depth and point count to the fastener, and keep impact sockets for impact tools.
Questions about socket sets
What is a good socket set to start with?
A good starting socket set covers one drive size well rather than spreading thin across several. A three-eighths drive set in the sizing system your equipment uses gives a usable range for engine, brake and body fasteners. Add deep sockets and a short extension so you can reach recessed nuts. Check that the case holds each socket in a marked position so missing pieces are obvious.
What is the best size socket set to buy?
The right socket set size depends on the fasteners you plan to turn, not on a single number. Drive size matters more than piece count: quarter-inch for small work, three-eighths for general repair and half-inch for large fasteners. Piece count then fills out the range, so a set with more sockets in your sizing system is more useful. Buy the drive size that matches your job and let the count follow.
Do I need metric and SAE sockets in one set?
You need both metric and SAE sockets only if you work on equipment from both sizing systems. Many vehicles use one system throughout, so a set in that system covers the fasteners you meet. A mixed set helps when your garage holds machines from different makers. Check the fasteners on your equipment before you decide which system to buy.
Should I buy impact-rated sockets?
Impact-rated sockets are the right choice when you use a powered impact wrench, because they are built for repeated hammering. Hand sockets can crack or split when driven by an impact tool, so keep the two types separate. For hand ratchet work, standard sockets are enough and cost less. Match the socket rating to the tool, and never use a hand socket on an impact driver.